기기를 수리하세요 커뮤니티 상점

DeWalt DW920 Motor Replacement

필요한 것

  1. DeWalt DW920 Motor Replacement, Disassembly: 1 단계, 이미지 1/1

    • Using an H-5.0 bit driver remove the four T-10 Torx screws.

    편집

  2. DeWalt DW920 Motor Replacement: 2 단계, 이미지 1/1

    • Use 2 H-5.0 bit drivers to take out the main bolt and head.

    • There will be blue locktite on the tread.

    편집

  4. DeWalt DW920 Motor Replacement: 3 단계, 이미지 1/1

    • Carefully remove the two halves of the handle.

    편집

  5. DeWalt DW920 Motor Replacement, Motor: 4 단계, 이미지 1/1

    • Gently lift the motor and trigger mechanism out from the frame of the drill.

    편집

  6. DeWalt DW920 Motor Replacement: 5 단계, 이미지 1/1

    • Locate where the motor assembly is attached to the trigger mechanism and carefully detach the wires at their solder points.

    • Mark where the two cables was connected using a masking tape or similar.

    편집

  7. DeWalt DW920 Motor Replacement: 6 단계, 이미지 1/1

    • Solder the new motor assembly wires to the trigger mechanism in the same fashion that the old motor was.

    • Remember to check the markers from the step before and solder the cables on the right place.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Stephen Rada

회원 가입일: 03/11/16

433 평판

안내서 4개 작성하였습니다

배지: 9

배지 +6개 더

팀

UMass Dartmouth, Team 8-2, Botvin Spring 2016 UMass Dartmouth, Team 8-2, Botvin Spring 2016 회원

UMASSD-BOTVIN-S16S8G2

2 회원들

안내서 6개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 2

전체 시간: 794