Skip to main content

소개

Remember to follow the battery removal steps before proceeding with replacing the RAM. In this guide, you will lift the keyboard cable and remove the RAM component out of your device. Remove these components carefully to prevent damage. You will need a plastic opening tool and a screwdriver for these steps.

  1. Flip your laptop over to view the bottom and the two locks.
    • Flip your laptop over to view the bottom and the two locks.

  2. Slide the two locks away from each other.
    • Slide the two locks away from each other.

    • Sliding these locks will loosen the battery to allow removal.

  3. Pull the battery out of the laptop. Your laptop's battery should be completely removed.
    • Pull the battery out of the laptop.

    • Your laptop's battery should be completely removed.

  4. 아이폰 배터리 수리 키트

    Only $29.99

    Buy Now

    아이폰 배터리 수리 키트

    Only $29.99

    Buy Now
  5. Remove the eleven 5mm palmrest screws from the bottom of the laptop with a Phillips #PH00 screw.
    • Remove the eleven 5mm palmrest screws from the bottom of the laptop with a Phillips #PH00 screw.

    • Remove the two 3mm hard drive screws from the bottom of the laptop with a Phillips #PH00 screw.

  6. Flip over and open the laptop to view the keyboard. Use a plastic opening tool to press down on four clips, one by one.
    • Flip over and open the laptop to view the keyboard.

    • Use a plastic opening tool to press down on four clips, one by one.

    • Press down on the clips and pull the tool towards you to pry the keyboard loose.

    • The four clips are above the Esc, F6, F11, and Delete keys.

  7. Remove the keyboard carefully. Make sure to lift the keyboard gently, because a cable is connected to the back. Flip the keyboard over to find  the keyboard cable.
    • Remove the keyboard carefully.

    • Make sure to lift the keyboard gently, because a cable is connected to the back.

    • Flip the keyboard over to find the keyboard cable.

    • Pull the cable labeled "UP" out to disconnect it from the laptop.

  8. Find the RAM and pull apart the two clips. After pulling apart both clips, the RAM component will snap up. After pulling apart both clips, the RAM component will snap up.
    • Find the RAM and pull apart the two clips.

    • After pulling apart both clips, the RAM component will snap up.

  9. Remove the RAM. Remove the RAM.
    • Remove the RAM.

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Kristy Mayo

회원 가입일: 2016년 09월 15일

847 평판

안내서 3개 작성하였습니다

University of North Texas, Team 1-3, Campbell Fall 2016 University of North Texas, Team 1-3, Campbell Fall 2016 회원

UNT-CAMPBELL-F16S1G3

2 회원들

안내서 3개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 2

지난 7일: 9

지난 30일: 29

전체 시간: 998