기기를 수리하세요 커뮤니티 상점

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

Dell Latitude X300 Palm Rest/Track Pad Replacement

소개

This guide is for the removal and installation of new track pad and palm rest of the Dell Latitude X300

필요한 것

  1. Dell Latitude X300 Palm Rest/Track Pad Replacement, Battery: 1 단계, 이미지 1/1

    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

    번역하기

  2. Dell Latitude X300 Palm Rest/Track Pad Replacement: 2 단계, 이미지 1/1

    • Slide the battery out of the laptop.

    번역하기

  3. Dell Latitude X300 Palm Rest/Track Pad Replacement, Keyboard: 3 단계, 이미지 1/1

    • Remove the four 4 mm Phillips #0 screws from the bottom of the laptop.

    번역하기

  4. Dell Latitude X300 Palm Rest/Track Pad Replacement: 4 단계, 이미지 1/2 Dell Latitude X300 Palm Rest/Track Pad Replacement: 4 단계, 이미지 2/2

    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

    번역하기

  5. Dell Latitude X300 Palm Rest/Track Pad Replacement: 5 단계, 이미지 1/1

    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

    번역하기

  6. Dell Latitude X300 Palm Rest/Track Pad Replacement: 6 단계, 이미지 1/1

    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

    번역하기

  7. Dell Latitude X300 Palm Rest/Track Pad Replacement: 7 단계, 이미지 1/1

    • Remove the flexible ribbon from the ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

    번역하기

  8. Dell Latitude X300 Palm Rest/Track Pad Replacement, Palm Rest/Track Pad: 8 단계, 이미지 1/1

    • Position the laptop so that the bottom is facing upward.

    • Remove the three #0 4 mm screws holding the bottom of the palm rest.

    번역하기

  9. Dell Latitude X300 Palm Rest/Track Pad Replacement: 9 단계, 이미지 1/1

    • Return the laptop to proper position and open the screen.

    • Remove the six #0 4 mm screws holding in the palm rest.

    번역하기

  10. Dell Latitude X300 Palm Rest/Track Pad Replacement: 10 단계, 이미지 1/1

    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

    번역하기

  11. Dell Latitude X300 Palm Rest/Track Pad Replacement: 11 단계, 이미지 1/1

    • Lift up on the small ZIF connector and remove ribbon.

    • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 8명과 함께

Thomas Wong

회원 가입일: 01/20/12

23 평판

안내서 2개 작성하였습니다

배지: 7

배지 +4개 더

팀

Cal Poly, Team 11-20, Maness Winter 2012 Cal Poly, Team 11-20, Maness Winter 2012 회원

CPSU-MANESS-W12S11G20

4 회원들

안내서 7개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 859