메인 콘텐츠로 스킵하기

소개

Before the majority of components can be accessed to be replaced, the back panel will need to come off.

부품

지정된 부품이 없습니다.

  1. Turn the laptop upside down.
    • Turn the laptop upside down.

    • Make sure the laptop is turned off.

    • Using the T5 Torx Screwdriver, remove the ten 3 mm long screws from the perimeter of the back of the laptop.

  2. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  3. Open up the information panel door (on the middle of the back side). While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.
    • Open up the information panel door (on the middle of the back side).

    • While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.

  4. Carefully lift 2  corners of the back panel upwards, releasing the whole panel. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.
    • Carefully lift 2 corners of the back panel upwards, releasing the whole panel.

    • Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Brandon Schmidt

회원 가입일: 2018년 10월 04일

738 평판

안내서 3개 작성하였습니다

UW Stout, Team S6-G1, Ogden Fall 2018 UW Stout, Team S6-G1, Ogden Fall 2018 회원

UWSTOUT-OGDEN-F18S6G1

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 8

지난 7일: 59

지난 30일: 241

전체 시간: 1,780