Deutz Brake Cylindern Disassembly

소개

One of the types of brake slave cylinder on this tractor is a hydraulically assisted type.

This uses 18 bar hydraulic fluid that actuates the brakes. A common problem is rust building up inside the hand brake mechanism. This is a disassembly guide since most manuals don't seem to show how. New cylinders are also very expensive.

1 단계 Overveiw

Deutz Brake Cylindern Disassembly, Overveiw: 1 단계, 이미지 1/2

Deutz Brake Cylindern Disassembly, Overveiw: 1 단계, 이미지 2/2

Here is all the parts removed so you have an ide of what is to come.

편집

2 단계

This is the cylinders placement on the center housing.

편집

3 단계

First we will remove the adjuster bolt, untighten the nut with 17mm spanner and then unscrew the bolt with a 8mm spanner.

편집

4 단계

Next remove the locking ring with lock ring pliers.
Flip the cylinder over.

편집

5 단계

Remove this bigger lock ring taking care since the spring is under some tension.

편집

6 단계

Deutz Brake Cylindern Disassembly: 6 단계, 이미지 3/3

If your cylinder is in good condition you might be able to get the piston out with compressed air but mine is rusted in place.
So I used a greasegun and some special fittings. A brake pipe fitting threaded for a grease nipple.
Replace the air bleed nipple with the greasegun nipple.

편집

7 단계

Deutz Brake Cylindern Disassembly: 7 단계, 이미지 3/3

Plug the hydraulic inlet and use the greasegun to force the parts out.
First comes the plunger that in this case was rusted in place.
Next the piston.

편집

8 단계

Deutz Brake Cylindern Disassembly: 8 단계, 이미지 3/3

Next turn it over and use a 17mm spanner to remove the hand brake arm bolt.
Then using a scribe mark the end positions for the arm so you can get it back in the right rotation. Both the arm and the inner pusher have splines so this is a good thing to do.

편집

9 단계

Remove the arm and flip it top side upp.

편집

10 단계

Deutz Brake Cylindern Disassembly: 10 단계, 이미지 3/3

The handbrake axle is locked by a small pin marked with the red arrow. I used a welder and a slidehammer to remove this.

편집

11 단계

Deutz Brake Cylindern Disassembly: 11 단계, 이미지 3/3

Next use the slidehammer and a m10 threaded end to remove the habdbrake axle like in picture 2.

편집

12 단계

Remove the screw that stops the adjuster parts from rotating.

편집

13 단계

Deutz Brake Cylindern Disassembly: 13 단계, 이미지 3/3

Now we will have to separate these two parts to get the handbrake actuator out.
Using a m10 bolt and a metric pipe thread I forced the to rotate in different directions which broke them free,

편집