주요 콘텐츠로 건너뛰기

DigiLand DL1010Q Front and Rear Cameras Replacement

필요한 것

  1. DigiLand DL1010Q Front and Rear Cameras Replacement, Rear Case: 1 단계, 이미지 1/1
    • With a J00 Philips head screwdriver, unscrew the two 4mm black screws located at the bottom of the device.

    • Before disassembling your device, be sure it is powered off.

  2. DigiLand DL1010Q Front and Rear Cameras Replacement: 2 단계, 이미지 1/2 DigiLand DL1010Q Front and Rear Cameras Replacement: 2 단계, 이미지 2/2
    • Using a plastic opening tool, begin softly prying open device by first inserting it in between the front and back panels.

    • Continue prying the edges while moving around the device's perimeter until the back can be easily removed.

  3. DigiLand DL1010Q Front and Rear Cameras Replacement: 3 단계, 이미지 1/1
    • Carefully lift back panel away from the body of the device.

    • Speaker wires are connected to both the front and back panel.

  4. DigiLand DL1010Q Front and Rear Cameras Replacement, Front and Rear Cameras: 4 단계, 이미지 1/1
    • Begin by grabbing the tweezers and locating the ZIF ( zero Insertion Force) connector.

  5. DigiLand DL1010Q Front and Rear Cameras Replacement: 5 단계, 이미지 1/1
    • Insert the tweezers into the black part of the ZIF connector and lift it in an upwards motion. By lifting the connection, you will see it will free the circuit strip.

  6. DigiLand DL1010Q Front and Rear Cameras Replacement: 6 단계, 이미지 1/2 DigiLand DL1010Q Front and Rear Cameras Replacement: 6 단계, 이미지 2/2
    • Take the tweezers and carefully grab the camera closest to the logic board and then pulling in an upwards motion will release both cameras from the device.

    • Set the cameras aside.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Marissa Saidy

회원 가입일: 09/28/15

354 평판

안내서 2개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 300