소개

Use this guide to remove the front and rear cover of the Canon PowerShot SD1100 IS.

부품

부품은 필요하지 않습니다.

Remove wrist strap and battery.
  • Remove wrist strap and battery.

댓글 쓰기

Remove 2 screws from each side of the camera (4 total, 0.102 in).
  • Remove 2 screws from each side of the camera (4 total, 0.102 in).

  • Remove 2 screws from the bottom on the camera (0.138 in).

  • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

댓글 쓰기

  • Gently pull off the front cover.

  • The plate on the side should come off.

  • Gently pull off the back cover.

댓글 쓰기

  • The cases should now be removed.

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore - 답글

oh yes , i agree lol

elbala80 -

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Tyler Grossheim

회원 가입일: 2011년 01월 25일

1,359 평판

안내서 6개 작성하였습니다

Cal Poly, Team 3-32, Regan Winter 2011 Cal Poly, Team 3-32, Regan Winter 2011 회원

CPSU-REGAN-W11S3G32

3 회원들

안내서 8개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 3,141