소개

This guide shows how to fully disassemble a Garmin Nuvi 1200 to replace the logic board.

부품

부품은 필요하지 않습니다.

Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.
  • Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.

    • Once the tool is inserted it can slide around the entire device.

댓글 쓰기

Remove four small T5 torx screws.
  • Remove four small T5 torx screws.

    • Be gentle, the screws are easily stripped.

댓글 쓰기

Mac RAM 키트
Mac 속도를 높이십시오. 메모리를 최대한 활용하십시오.
Mac RAM 키트
Mac에서 메모리를 더 많이 확보하십시오.
Lift cover off of unit. Be careful not to lose small rubber piece on the bottom right corner.
  • Lift cover off of unit.

  • Be careful not to lose small rubber piece on the bottom right corner.

댓글 쓰기

Disconnect ribbon cable from logic board.
  • Disconnect ribbon cable from logic board.

댓글 쓰기

Remove two T5 torx screws holding down logic board.
  • Remove two T5 torx screws holding down logic board.

  • Disconnect battery.

댓글 쓰기

Gently lift the logic board out of the unit
  • Gently lift the logic board out of the unit

    • Be careful not to damage the battery connector on the top of the unit.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 5명이 해당 안내서를 완성하였습니다.

Zachary Landau

회원 가입일: 2010년 11월 28일

178 평판

안내서 1개 작성함

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 4

전체 시간: 4,913