부품

부품은 필요하지 않습니다.

  1. Turn off the camera.
    • Turn off the camera.

      • Locate the power switch on the front of the camera below the camera lens.

      • Slide the switch to the off position.

    댓글 쓰기

  2. Locate the 3 screws that hold the back cover to the camera.
    • Locate the 3 screws that hold the back cover to the camera.

      • One screw is located on the film opener side of the camera.

      • The other screws are located on the opposite side of the camera.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

    댓글 쓰기

    • Open the film door to remove the back cover.

      • Slide the film door lever to the left until the film door opens.

    댓글 쓰기

    • Use a plastic opening tool to pry the case open until a small gap is present.

      • Repeat this process at the top and bottom of the film door to loosen it.

    댓글 쓰기

    • Grab the top and bottom of the case firmly as shown.

      • Gently remove the back of the camera case with a slight twisting motion.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

David Cottrell

회원 가입일: 2011년 10월 04일

58 평판

안내서 5개 작성하였습니다

UW Stout, Team 1-2, Zhou Fall 2011 UW Stout, Team 1-2, Zhou Fall 2011 회원

UWSTOUT-ZHOU-F11S1G2

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 6

전체 시간: 434