소개

Separating the logic board from the face plate.

부품

부품은 필요하지 않습니다.

Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.
  • Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.

댓글 쓰기

Remove the top screw on the back panel.
  • Remove the top screw on the back panel.

댓글 쓰기

  • Slide off the case to expose the internal components of the receiver.

댓글 쓰기

  • Unscrew the three screws on top of the face plate.

댓글 쓰기

  • Unscrew the one screw on the bottom of the front panel.

댓글 쓰기

  • Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force.

댓글 쓰기

  • On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws.

댓글 쓰기

  • You will see the same snaps along the top of the logic board. Press the heads of the snaps down and pull the logic board out and up.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Ryan

회원 가입일: 2010년 04월 13일

86 평판

안내서 3개 작성하였습니다

Cal Poly, Team 27-92, Amido Spring 2010 Cal Poly, Team 27-92, Amido Spring 2010 회원

CPSU-AMIDO-S10S27G92

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 7

전체 시간: 2,150