1. Remove the four rubber screw covers from encircled locations.
    • Remove the four rubber screw covers from encircled locations.

    • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

    • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

    댓글 쓰기

  2. Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
    • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

    • Be mindful of location and magnitude of applied force, so as not to damage the case.

    댓글 쓰기

    • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

    댓글 쓰기

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use fingernails to pry off minor LCD mount, as shown.

    • Remove the minor LCD

    댓글 쓰기

    • Unlock the LCD main board connectors shown in red boxes on the picture .

    • Use tweezers as necessary.

    댓글 쓰기

    • Place finger nails on the connector tab as shown.

    • Lift the connector tab up.

    댓글 쓰기

    • Pull/pivot the LCD main board as shown in order to remove.

    댓글 쓰기

    • Use a tweezers to lift up the main LCD

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Van

회원 가입일: 2010년 06월 24일

7 평판

안내서 8개 작성하였습니다

Cal Poly, Team 2-10, Johann Summer 2010 Cal Poly, Team 2-10, Johann Summer 2010 회원

CPSU-JOHANN-R10S2G10

4 회원들

안내서 20개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 1,140