이 버전에는 잘못된 편집 사항이 있을 수 있습니다. 최신 확인된 스냅샷으로 전환하십시오.
필요한 것
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Using a Phillips #00 screwdriver, remove the four 6.4mm screws on the back casing.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Using your fingernail or a spudger, pry open the accessory port cover on the top of the device.
-
Using a Phillips #00 screwdriver, remove the two 5.4mm screws hidden beneath the accessory port cover.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the two 5.4mm Phillips #00 screws on the bottom of the device near the charging port.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Beginning at the sides of the device, use a plastic opening tool to separate the front and rear cases.
-
Continue working your way around the device gently prying it open.
-
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Gently separate the two cases, minding the battery and the touch screen controller connectors holding the two cases together.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Using a spudger, free the touch screen controller flex cable by gently prying up the connection.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Free the battery cable by gently prying up on the connection with a spudger.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
With the help of a spudger, gently pry off and remove the battery cable retainer on the back casing assembly.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Using a Phillips #00 screwdriver, remove the two 5.0mm blue battery case screws.
-
Remove the plastic battery retaining bar.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Using your finger or a spudger, lift the battery out and remove it.
-
Guide the battery wires through the hole in the back casing as you remove the battery.
-
다른 6명이 해당 안내서를 완성하였습니다.