기기를 수리하세요 커뮤니티 상점

Disassembling Sony Clie PEG-SL10

소개

This guide shows you how to disassemble a Sony Clie PEG-SL10 through an easy step-by-step process. All you need to perform this repair is a Phillips #0 screwdriver and no additional special skills are required.

This is a precursor to any other repair you may want to do on this device and also allows you to get a good look at its internal workings.

Attached to this guide at the bottom of the page is the Sony Clie PEG-SL10 User Manual.

필요한 것

  1. Disassembling Sony Clie PEG-SL10, Disassembling Sony Clie PEG-SL10: 1 단계, 이미지 1/1

    • Start by holding your Sony Clie PEG-SL10 face-up in your hand.

    편집

  2. Disassembling Sony Clie PEG-SL10: 2 단계, 이미지 1/1

    • Turn over your Sony Clie and unlock the cover slide lock.

    편집

  3. Disassembling Sony Clie PEG-SL10: 3 단계, 이미지 1/1

    • After unlocking the cover slide lock, remove the cover and set aside.

    편집

  4. Disassembling Sony Clie PEG-SL10: 4 단계, 이미지 1/1

    • Turn your Sony Clie face-up.

    • Using a Phillips #0 screwdriver, remove the six case screws on the sides and bottom of the device.

    편집

  5. Disassembling Sony Clie PEG-SL10: 5 단계, 이미지 1/1

    • Remove the front case by gently lifting away from the device.

    편집

  7. Disassembling Sony Clie PEG-SL10: 6 단계, 이미지 1/1

    • Turn the Sony Clie face down and open the back case by prying open the left side of the device.

    • It will open like a book connected by hinges on the right side.

    편집

  8. Disassembling Sony Clie PEG-SL10: 7 단계, 이미지 1/1

    • Gently pry off the right side off the back panel and set it aside, leaving room for the scroll wheel at the upper right corner.

    편집

  9. Disassembling Sony Clie PEG-SL10: 8 단계, 이미지 1/1

    • Using a Phillips #0 screwdriver, remove the two screws holding the scroll wheel in place.

    편집

  10. Disassembling Sony Clie PEG-SL10: 9 단계, 이미지 1/1

    • Pull out both sides of the clip to remove the scroll wheel power cable from the device.

    편집

  11. Disassembling Sony Clie PEG-SL10: 10 단계, 이미지 1/1

    • Using a Phillips #0 screwdriver, unscrew the two screws towards the bottom sides of the Sony Clie to remove the battery harness.

    편집

  12. Disassembling Sony Clie PEG-SL10: 11 단계, 이미지 1/1

    • Pull the power cable from the socket located above the upper right side of the battery harness.

    편집

  13. Disassembling Sony Clie PEG-SL10: 12 단계, 이미지 1/1

    • Gently pull out the clips to remove the bottom power cables from the motherboard after removing the battery harness.

    편집

  14. Disassembling Sony Clie PEG-SL10: 13 단계, 이미지 1/1

    • Rotate the motherboard 180 degrees so that it is upside down facing toward you to expose the power cables on the other side.

    편집

  15. Disassembling Sony Clie PEG-SL10: 14 단계, 이미지 1/1

    • Gently pull out the clips to remove the top power cables from the motherboard.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

첨부 문서

작성자

다른 기여자 5명과 함께

Steve

회원 가입일: 10/18/11

9 평판

안내서 1개 작성함

배지: 5

배지 +2개 더

팀

James Madison, Team 1-4, Allen Fall 2011 James Madison, Team 1-4, Allen Fall 2011 회원

JMU-ALLEN-F11S1G4

3 회원들

안내서 4개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 14

전체 시간: 1,706