부품

부품은 필요하지 않습니다.

  1. Using the Phillips #0 in the bit driver, carefully loosen and remove the single  5mm screw.
    • Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.

    • With the retaining screw removed, lift the panel upwards to separate it from the netbook.

    댓글 쓰기

  2. To replace the panel, do step 1 in reverse:
    • To replace the panel, do step 1 in reverse:

      • Align the panel slots in the appropriate grooves and set in place.

      • With the bit driver, replace the screw to secure the RAM panel.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Using the bit driver and the Phillips bit, remove both of the panel's retaining screws.

    • With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.

    • The hard drive is located beneath this cover and is now accessible.

    댓글 쓰기

    • To replace the hard drive panel, do step 3 in reverse:

      • Place the panel back in its original position and press down.

      • If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.

      • With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

회원 가입일: 2013년 10월 18일

943 평판

안내서 9개 작성하였습니다

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013 회원

CLEM-BENSON-F13S14G2

3 회원들

안내서 9개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 7

전체 시간: 598