주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

This guide is a complete, all-around guide to disassembling this model laptop. Use this guide to replace any of the parts in the laptop. Stop when you get to the part you want to replace and simply follow the guide backwards from where you stopped to reassemble your device.

부품

지정된 부품이 없습니다.

  1. Remove the 8 small screws.
    • Remove the 8 small screws.

  2. Remove the other 6 screws. Remove the hard disk and the RAM slots.
    • Remove the other 6 screws.

    • Remove the hard disk and the RAM slots.

  3. This is the hard disk - Hitachi 500 GB
    • This is the hard disk - Hitachi 500 GB

  4. Ensure that the hard disk has been removed. Carefully detach the bottom cover.
    • Ensure that the hard disk has been removed. Carefully detach the bottom cover.

  5. Once the bottom cover is removed, your device should look like this.
    • Once the bottom cover is removed, your device should look like this.

  6. Remove the 4 screws to detach the battery.
    • Remove the 4 screws to detach the battery.

    • Remove all of the sticky tape.

    • Carefully disconnect the small power connector by using a tool to push the connector out through the small gap in the middle of the connector.

    • The connector won't come out all the way, because the battery pack is in its way.

  7. OPEN ALL THE TABS

    RAM Upgrade Kits for Mac

    키트 쇼핑하기

    Enough RAM
    For All The Tabs

    키트 쇼핑하기
  8. This is the Samsung 7.4V 45Wh battery. Ensure that the battery is removed before continuing.
    • This is the Samsung 7.4V 45Wh battery.

    • Ensure that the battery is removed before continuing.

  9. When the battery is removed, this is how it will look.
    • When the battery is removed, this is how it will look.

  10. Remove the processor fan.
    • Remove the processor fan.

    • There are 2 screws holding it in place. Loosen and remove them.

  11. This is the processor fan.
    • This is the processor fan.

  12. Remove the processor heat sink.
    • Remove the processor heat sink.

    • 3 screws hold this part in place. Loosen and remove them.

  13. Disconnect the antenna cables from the WiFi card.
    • Disconnect the antenna cables from the WiFi card.

    • Remove the screw.

    • Be sure to match the colors when reattaching the cables.

  14. Remove the screw.
    • Remove the screw.

    • Lift the latch upwards to loosen the cable.

  15. Remove the screw.
    • Remove the screw.

  16. Remove the screw.
    • Remove the screw.

  17. To remove the Motherboard, carefully disconnect the cables.
    • To remove the Motherboard, carefully disconnect the cables.

  18. This is the Motherboard - there is a front and rear view. This is the Motherboard - there is a front and rear view.
    • This is the Motherboard - there is a front and rear view.

결론

To reassemble your device, follow these instructions in reverse order.

다른 31명이 해당 안내서를 완성하였습니다.

Jose Gustavo Abreu Murta

회원 가입일: 2010년 07월 06일

2,800 평판

안내서 7개 작성하였습니다

Hello,

Do you know where can i reset the Bios CMOS in that motherboard?

I think there are people who wants to know becose system upgrade is leading to bios ACPI Error.

Thanks for your help

Luis Orland - 답글

No, I do not know where is a reset pin of BIOS.

Try to disconnect NVRAM battery.

Wait 15 minutes and reconnect again.

Jose Gustavo Abreu Murta - 답글

To reset BIOS this NP530U3, only disconnect all power supply (MAIN battery, CMOS battery and power source). And hold press POWER button for 1 min.

warmdk - 답글

I try it but don't work, do you know another way to do this

manhique -

Hello,

I have seen many screens with model number LTN140AT21-XXX for this laptop. My laptop NP530u4b has a screen LTN140AT21-802. I would like to know if I can use a LTN140AT21-002 screen, or if only is good a screen with number LTN140AT21-8.

thanks for your help.

alex - 답글

댓글 쓰기

조회 통계:

24 시간 전: 6

7일 전: 44

30일 전: 259

전체 시간: 48,262