기기를 수리하세요 커뮤니티 상점

Ecovacs Deebot 900 Front Bumper Replacement

소개

The front bumper of the Ecovacs Deebot 900 is used to sense obstacles in its path. A malfunctioning front bumper can cause the Deebot to move in a circular fashion. Use this guide to remove or replace the front bumper on your Ecovacs 900 Deebot.

필요한 것

  1. Ecovacs Deebot 900 Front Bumper Replacement, Battery: 1 단계, 이미지 1/1

    • Remove all the brushes from the Deebot.

    편집

  2. Ecovacs Deebot 900 Front Bumper Replacement: 2 단계, 이미지 1/1

    • Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

    편집

  3. Ecovacs Deebot 900 Front Bumper Replacement: 3 단계, 이미지 1/1

    • Remove the battery cover.

    편집

  5. Ecovacs Deebot 900 Front Bumper Replacement: 4 단계, 이미지 1/1

    • Using the two white straps on the sides of the battery, gently remove the battery. ​

    • Be careful not to rip out the battery cable.

    편집

  6. Ecovacs Deebot 900 Front Bumper Replacement: 5 단계, 이미지 1/1

    • Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

    편집

  7. Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: 6 단계, 이미지 1/2 Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: 6 단계, 이미지 2/2

    • Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    편집

  8. Ecovacs Deebot 900 Front Bumper Replacement: 7 단계, 이미지 1/1

    • Remove the black strip on the bottom of the bumper.

    편집

  9. Ecovacs Deebot 900 Front Bumper Replacement: 8 단계, 이미지 1/2 Ecovacs Deebot 900 Front Bumper Replacement: 8 단계, 이미지 2/2

    • Carefully lift up the bumper untill it pops out of place.​

    편집

  10. Ecovacs Deebot 900 Front Bumper Replacement: 9 단계, 이미지 1/2 Ecovacs Deebot 900 Front Bumper Replacement: 9 단계, 이미지 2/2

    • Disconnect the two cables connecting the bumper to the body of the Deebot.

    • Remove the front bumper from the device.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Gillian Blumer

회원 가입일: 01/16/20

555 평판

안내서 3개 작성하였습니다

배지: 11

배지 +8개 더

팀

Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020 Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020 회원

ERAU-RAUCH-S20S6G1

3 회원들

안내서 17개 작성하였습니다

댓글 한 개

Where may I buy the front bumper assembly? I'm trying to replace one for a deebot 901 but the mfg tells me they don't see the part directly.

Chris Khacherian - 답글

댓글 쓰기

조회 통계:

24 시간 전: 3

7일 전: 41

30일 전: 217

전체 시간: 9,683