Etekcity Lasergrip 1080 Trigger Replacement

소개

This guide will show you how to repair a trigger that has a faulty connection. If the trigger will depress and not return to its original position or if it will not even depress, this will be necessary. The tool needed is a screwdriver. There are no hazards in this guide.

필요한 것

1 단계 Battery

Etekcity Lasergrip 1080 Trigger Replacement, Battery: 1 단계, 이미지 1/1

Pull the battery cover away from the handle by gripping near the thumb groove.

번역하기

2 단계

Gently pull the battery out of the handle.
Excessive force could damage wires.

번역하기

3 단계

Disconnect the battery by pulling the connector away from it.
Positive first
Negative second
When replacing the battery, this order is reversed.

번역하기

4 단계 Buttons

Etekcity Lasergrip 1080 Trigger Replacement, Buttons: 4 단계, 이미지 1/2

Etekcity Lasergrip 1080 Trigger Replacement, Buttons: 4 단계, 이미지 2/2

Remove the battery cover from the device by pulling it straight out.

번역하기

5 단계

Using the plastic opening tool remove the front and rear yellow covers.
When removing the back cover, be careful not to lose the buttons as they are not connected.

번역하기

6 단계

Remove the two 3.1 mm Phillips #0 screws.

번역하기

7 단계

Pull the two halves apart.
Be careful not to lose any components on the inside.

번역하기

8 단계

Realign the buttons with the button terminals.
Red terminal to red button.
Orange terminal to orange button.
Yellow terminal to yellow button.

번역하기

9 단계 Etekcity Lasergrip 1080 Trigger Replacement

Etekcity Lasergrip 1080 Trigger Replacement, Etekcity Lasergrip 1080 Trigger Replacement: 9 단계, 이미지 1/2

Etekcity Lasergrip 1080 Trigger Replacement, Etekcity Lasergrip 1080 Trigger Replacement: 9 단계, 이미지 2/2

Carefully pull the trigger out.
The trigger is spring loaded, so be careful that you do not lose the spring as you pull the trigger out.
To put the trigger back in, align the peg with the hole in the handle and align the shaft with the button terminal.