Fluke 77 Series III Front Panel Replacement

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

소개

This is a guide for replacing the front panel of the Fluke 77 Series III Multimeter. Front panel removal is a prerequisite-only guide for replacing all other parts of the Fluke 77 Series III Multimeter.

필요한 것

1 단계 Front Panel

Fluke 77 Series III Front Panel Replacement, Front Panel: 1 단계, 이미지 1/1

Be sure any test leads are out and the multimeter is off before opening the device.
Turn the multimeter so it is display side down.
Lift up the back stand of the device by putting your thumb in the curved well at the bottom of the device, so you have access to the two covered screws below.

번역하기

2 단계

Use your Phillips #2 Screwdriver to remove the four black 21 mm Phillips #2 screws.

번역하기

3 단계

Turn the Fluke 77 Series III Multimeter back over so that it is display side up.
Pry the front panel from the back panel at the seam.
If the front panel does not come off easily, move a plastic opening tool along the seam until the panels separate completely.