Skip to main content

소개

Use this guide to replace the battery door.

부품

No parts specified.

  1. Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.
    • Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.

  2. Locate the battery door.
    • Locate the battery door.

  3. Locate the latch on the battery door.
    • Locate the latch on the battery door.

    • Use your finger pry to it open where it says "BATT."

  4. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  5. Remove the battery from the camera by pulling the battery door outward.
    • Remove the battery from the camera by pulling the battery door outward.

  6. Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.
    • Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.

  7. Squeeze the camera placing a thumb on the tab marked CE.
    • Squeeze the camera placing a thumb on the tab marked CE.

    • Pull the back half of the camera firmly away from the camera body.

  8. Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver. The plastic strip will now come off the camera body.
    • Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver.

    • The plastic strip will now come off the camera body.

결론

To reassemble your device, follow these instructions in reverse order.

Eric Nicolai

회원 가입일: 2011년 01월 10일

679 평판

안내서 6개 작성하였습니다

Cal Poly, Team 13-5, Forte Winter 2011 Cal Poly, Team 13-5, Forte Winter 2011 회원

CPSU-FORTE-W11S13G5

5 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 1,651