부품

부품은 필요하지 않습니다.

Use the Phillips #00 screwdriver to remove the 7 screws on the sides of the camera: Four 3.95mm Phillips screws located on the bottom of the camera Two 3.95mm Phillips screws located on the right side of the camera
  • Use the Phillips #00 screwdriver to remove the 7 screws on the sides of the camera:

    • Four 3.95mm Phillips screws located on the bottom of the camera

    • Two 3.95mm Phillips screws located on the right side of the camera

    • One 3.95mm Phillips screw located on the left side of the camera

댓글 쓰기

Slide open the battery compartment cover with your thumb.
  • Slide open the battery compartment cover with your thumb.

댓글 쓰기

아버지의 날 선물 안내
아버지 뿐만 아니라 다른 분들도 존중합시다—우리에게 수리하는 법을 가르쳐 주신 모든 멘토를 축하합시다.
아버지의 날 선물 안내
우리에게 수리하는 법을 가르쳐 주신 사람들을 존중합시다.
Wedge the edge of the spudger between the front and back case, near the corner of the flash. Carefully run the spudger along the right edge of the camera, creating an opening. Insert the spudger into the left side of the camera, above the screwhole. Then carefully run it along this edge.
  • Wedge the edge of the spudger between the front and back case, near the corner of the flash.

  • Carefully run the spudger along the right edge of the camera, creating an opening.

  • Insert the spudger into the left side of the camera, above the screwhole. Then carefully run it along this edge.

댓글 쓰기

Watch out for the orange ribbon that is still attached to the back cover when you lift it up. It is very delicate and might rip. Slowly lift the back cover straight up, lightly jiggling it if necessary.
  • Watch out for the orange ribbon that is still attached to the back cover when you lift it up. It is very delicate and might rip.

  • Slowly lift the back cover straight up, lightly jiggling it if necessary.

  • Remove the battery compartment cover.

댓글 쓰기

Gently insert the spudger under the clip holding the orange ribbon. The clip should lift up and the ribbon will slide out.
  • Gently insert the spudger under the clip holding the orange ribbon. The clip should lift up and the ribbon will slide out.

  • This step will free the back cover from the rest of the camera.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Sarthak Patel

회원 가입일: 2012년 04월 03일

1 평판

안내서 2개 작성하였습니다

Cal Poly, Team 14-8, Forte Spring 2012 Cal Poly, Team 14-8, Forte Spring 2012 회원

CPSU-FORTE-S12S14G8

5 회원들

안내서 8개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 3

전체 시간: 782