부품

부품은 필요하지 않습니다.

There are 4 black screws that need to be removed on the top of the lid.  A 1.5mm flathead screwdriver will work on the star shaped screw heads.
  • There are 4 black screws that need to be removed on the top of the lid. A 1.5mm flathead screwdriver will work on the star shaped screw heads.

  • Make note that two of the screws closest to the hinge are longer than the other two.

댓글 쓰기

Remove the two side screws. When reassembling you may need to press the front and back of the lid together when inserting these side screws so that the holes align.
  • Remove the two side screws.

  • When reassembling you may need to press the front and back of the lid together when inserting these side screws so that the holes align.

댓글 쓰기

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Use a plastic opening tool to remove the screen cover from the rest of the lid. Use a plastic opening tool to remove the screen cover from the rest of the lid.
  • Use a plastic opening tool to remove the screen cover from the rest of the lid.

댓글 쓰기

Your phone should look like the picture to the left. If reassembling from a previous step make sure the ribbon cable is properly situated before securing the front cover.
  • Your phone should look like the picture to the left.

  • If reassembling from a previous step make sure the ribbon cable is properly situated before securing the front cover.

댓글 쓰기

Remove one screw located on the left side of the phone with the pictured orientation in mind. This will release the logic board from the back case. Lift the board out of the case starting with the top. Continue to fold it forwards to access the ribbon cable still connecting it.
  • Remove one screw located on the left side of the phone with the pictured orientation in mind.

  • This will release the logic board from the back case.

  • Lift the board out of the case starting with the top. Continue to fold it forwards to access the ribbon cable still connecting it.

댓글 쓰기

Pull the logic board out with a pry stick gently from bottom to top at the current orientation. The ribbon cable will be connected underneath the logic board.  A small amount of force is required to disconnect them. Although some force is required to lift up the board, be careful as to not bend any of the pins on either side.
  • Pull the logic board out with a pry stick gently from bottom to top at the current orientation.

  • The ribbon cable will be connected underneath the logic board. A small amount of force is required to disconnect them.

  • Although some force is required to lift up the board, be careful as to not bend any of the pins on either side.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Raymond Caulder

회원 가입일: 2013년 03월 11일

22 평판

안내서 6개 작성하였습니다

Clemson, Team 13-3, Benson Spring 2013 Clemson, Team 13-3, Benson Spring 2013 회원

CLEM-BENSON-S13S13G3

3 회원들

안내서 14개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 4

전체 시간: 543