기기를 수리하세요 커뮤니티 상점

Game Boy Display Lines/Bars

작성자 Mitchell (또 다른 기여자 4명)
  • 댓글 3
  • 즐겨찾기 5
  • 완료: 6

난이도

보통

단계

5

소요 시간

30 초 - 1 시간

섹션

1

플래그

3

In Progress

진행 중

해당 안내서는 작업중입니다. 최근 변경 사항을 보려면 정기적으로 새로고침 하십시오!

Needs Better Images

더 나은 이미지가 필요함

더 나은 사진은 해당 안내서를 향상시킬 것입니다. 사진 촬영, 편집, 또는 새로운 업로드를 도와주십시오!

Member-Contributed Guide

회원-기여 안내서

해당 안내서는 저희 커뮤니티의 멋진 회원께서 작성하였습니다. iFixit 직원이 관리하지 않습니다.

소개

Fixing the common problem of lines/bars on the original Nintendo Gameboy.

  1. Remove the back housing by removing the 6 Tri-Point or Philip screws. Note: The last 2 screws are in the battery compartment. Note: The last 2 screws are in the battery compartment.

    • Remove the back housing by removing the 6 Tri-Point or Philip screws.

    • Note: The last 2 screws are in the battery compartment.

    편집

  2. Carefully lift up the top half of the system. Be careful, there's a ribbon cable that connects the top and bottom half of the system. Remove the ribbon cable for the next step.

    • Carefully lift up the top half of the system. Be careful, there's a ribbon cable that connects the top and bottom half of the system.

    • Remove the ribbon cable for the next step.

    편집

  4. Now there will be screws that mount the board to the front, carefully unscrew these. Now remove the board from the housing. Now put the batteries back into the compartment, so you can test the screen while you fix it.

    • Now there will be screws that mount the board to the front, carefully unscrew these.

    • Now remove the board from the housing.

    • Now put the batteries back into the compartment, so you can test the screen while you fix it.

    • Reconnect the the board to back housing with the ribbon cable.

    편집

  5. You're now going to turn the contrast ( the slider on the left) all the way up, and take your soldering iron and gently move it back and forth on the ribbon cable below the screen.

    • You're now going to turn the contrast ( the slider on the left) all the way up, and take your soldering iron and gently move it back and forth on the ribbon cable below the screen.

    • Make sure not to touch the screen itself.

    • Note: There may be a rubber strip covering the ribbon.

    편집

    • You will start to see the lines of pixels fade in and out, keep moving your iron back and forth until screen is completely black.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 6명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 4명과 함께

Mitchell

회원 가입일: 2016년 04월 03일

184 평판

안내서 1개 작성함

배지: 4

+1개 배지 추가

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 5

30일 전: 25

전체 시간: 3,539