기기를 수리하세요 커뮤니티 상점

Game Boy Speaker Replacement

소개

This guide explains how to replace the speaker in a first-generation Nintendo Game Boy system.

필요한 것

동영상 개요

  1. Game Boy Speaker Replacement, Batteries: 1 단계, 이미지 1/2 Game Boy Speaker Replacement, Batteries: 1 단계, 이미지 2/2

    • Switch your Game Boy off and remove the cartridge.

    번역하기

  2. Game Boy Speaker Replacement: 2 단계, 이미지 1/3 Game Boy Speaker Replacement: 2 단계, 이미지 2/3 Game Boy Speaker Replacement: 2 단계, 이미지 3/3

    • Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.

    • The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.

    • When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.

    번역하기

  3. Game Boy Speaker Replacement: 3 단계, 이미지 1/2 Game Boy Speaker Replacement: 3 단계, 이미지 2/2

    • Use a fingernail to pry each battery outward from the positive (+) terminal to remove them.

    • Dispose of used batteries properly!

    • Remove the batteries from your Game Boy before storing it for more than a month or so.

    번역하기

  4. Game Boy Speaker Replacement, Outer Case: 4 단계, 이미지 1/1

    • Remove the six Triwing screws from the back of the device.

    번역하기

  6. Game Boy Speaker Replacement: 5 단계, 이미지 1/1

    • Gently separate the device's front casing from the back casing after you remove the screws.

    • Be careful not to completely separate the casing halves, as they are still joined by a large ribbon cable that may be damaged.

    번역하기

  7. Game Boy Speaker Replacement: 6 단계, 이미지 1/1

    • Slide the front side of the casing down to expose the ribbon cable connector.

    번역하기

  8. Game Boy Speaker Replacement: 7 단계, 이미지 1/1

    • Grip the ribbon connector with your thumb and forefinger. Pull down gently until the connector, not the ribbon itself, comes out of its socket.

    • Separate the front and back casings.

    번역하기

  9. Game Boy Speaker Replacement, Speaker: 8 단계, 이미지 1/1

    • Remove the 10 Phillips #00 screws from the motherboard.

    번역하기

  10. Game Boy Speaker Replacement: 9 단계, 이미지 1/2 Game Boy Speaker Replacement: 9 단계, 이미지 2/2

    • Use a plastic opening tool to gently lift the motherboard up and remove it from the front plastic case.

    • Use caution when lifting the board since the speaker is attached.

    번역하기

  11. Game Boy Speaker Replacement: 10 단계, 이미지 1/3 Game Boy Speaker Replacement: 10 단계, 이미지 2/3 Game Boy Speaker Replacement: 10 단계, 이미지 3/3

    • Desolder the two wires connecting the speaker to the motherboard.

    • Remove the speaker.

    • If you're new to soldering, refer to this guide for tips that will help with desoldering the speaker wires and/or soldering the new ones in place.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 16명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 16명과 함께

Andrew Tramposch

회원 가입일: 06/24/10

2,225 평판

안내서 6개 작성하였습니다

배지: 17

배지 +14개 더

팀

Cal Poly, Team 3-2, Johann Summer 2010 Cal Poly, Team 3-2, Johann Summer 2010 회원

CPSU-JOHANN-R10S3G2

3 회원들

안내서 34개 작성하였습니다

댓글 2개

This is just a guide to remove the speaker not replacing it so change the title as it is misleading as people that following this will want know how to replace not remove only

Paul - 답글

As stated in the conclusion, you simply follow the steps in reverse to install your replacement speaker.

Jeff Suovanen -

댓글 쓰기

조회 통계:

24 시간 전: 4

7일 전: 79

30일 전: 250

전체 시간: 32,088