소개

Removing the logic board from the Garmin Nuvi 200

  1. Peel off the sticker from the bottom of the device to reveal two screws.
    • Peel off the sticker from the bottom of the device to reveal two screws.

    댓글 쓰기

  2. Remove two T5 Torx screws.
    • Remove two T5 Torx screws.

    댓글 쓰기

    • Insert a plastic opening tool in the gap between the front and rear casing.

    • Carefully work the tool around the gap, separating the two halves of the case.

      • Keep the power switch in place while removing the rear case.

    댓글 쓰기

    • Peel away the tape holding the ribbon cable in place.

    • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

    댓글 쓰기

    • Pull out the cable between the logic board and the speaker to disconnect them.

    댓글 쓰기

    • Remove the three screws from the logic board using the #00 Phillips screwdriver.

    • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

    댓글 쓰기

    • Detach the logic board form the battery by pulling out the cable.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Anjelica

회원 가입일: 2010년 04월 11일

504 평판

안내서 3개 작성하였습니다

Cal Poly, Team 25-90, Amido Spring 2010 Cal Poly, Team 25-90, Amido Spring 2010 회원

CPSU-AMIDO-S10S25G90

4 회원들

안내서 9개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 14

전체 시간: 9,607