기기를 수리하세요 커뮤니티 상점

Garmin Nuvi 2689LMT Main Circuit Board Replacement

소개

The main circuit board controls all aspects of the device. It also houses the Blue-tooth and satellite up-link components.

필요한 것

  1. Garmin Nuvi 2689LMT Main Circuit Board Replacement, Main Circuit Board: 1 단계, 이미지 1/1

    • Begin by removing the stand by depressing the tab and rocking the round interface back toward you, pulling it away from the Garmin unit.

    편집

  2. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 2 단계, 이미지 1/1

    • Remove the four, 4mm hex screws at the four corners of the device using a T5 bit.

    편집

  3. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 3 단계, 이미지 1/1

    • Place the unit screen-side down flat, with the bottom facing you. There are two seams, the one on top is artificial.

    • Pry open the seam with a prying tool.

    편집

  4. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 4 단계, 이미지 1/1

    • Firmly force a plastic spudger into the bottom seam and pry open a section. Use a prying/pushing motion to force the spudger into the unit.

    • Repeat this all the way around the seam.

    편집

  6. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 5 단계, 이미지 1/1

    • Do not attempt to separate the unit until all the tabs have been separated. Once the seam is completely separated, you can lift the back away from the screen easily.

    편집

  7. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 6 단계, 이미지 1/1

    • The battery is connected to the main circuit board via two wires, red and green in color, and is attached with a white connector.

    • Detach with a pry tool.

    편집

  8. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 7 단계, 이미지 1/1

    • The white battery is attached to the casing with an adhesive. Separate it with a prying tool.

    • Removing the battery protects it from damage and gives you more room to work.

    편집

  9. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 8 단계, 이미지 1/2 Garmin Nuvi 2689LMT Main Circuit Board Replacement: 8 단계, 이미지 2/2

    • Remove the four, 4mm hex screws with a T5 bit.

    • These are located near the four corners of the main circuit board, as shown.

    편집

  10. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 9 단계, 이미지 1/1

    • Carefully pick up and remove the main circuit board from the device’s plastic casing.

    편집

  11. Garmin Nuvi 2689LMT Main Circuit Board Replacement: 10 단계, 이미지 1/1

    • Remove the speaker - located on the device as shown - from the plastic casing using a prying tool. Use the prying tool around the entire rim of the speaker to ensure a clean removal.

    편집
결론

To reassemble your device, follow these instructions in reverse order, using a new circuit board.

작성자

다른 기여자 5명과 함께

Spencer

회원 가입일: 09/26/16

273 평판

안내서 2개 작성하였습니다

배지: 10

배지 +7개 더

팀

USF Tampa, Team 16-5, Eyestone Fall 2016 USF Tampa, Team 16-5, Eyestone Fall 2016 회원

USFT-EYESTONE-F16S16G5

3 회원들

안내서 5개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 2

30일 전: 10

전체 시간: 583