부품

부품은 필요하지 않습니다.

  1. Flip the device over and locate the battery compartment.
    • Flip the device over and locate the battery compartment.

    • Slide the battery release latch, which you can see in the picture, to the left until the battery is detached from its slot.

    • A distinguishable pop will be heard when the battery is fully released.

    댓글 쓰기

  2. Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process.
    • Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process.

    댓글 쓰기

    • Locate the RAM compartment cover below the battery compartment.

    • Locate the Phillips head screw securing RAM compartment to plastic chassis.

    • Loosen screw that is securing the RAM compartment with #00 Phillips head screwdriver.

    • Screw is permanently attached to the RAM compartment cover. Do not try to remove completely.

    댓글 쓰기

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Once the screw is sufficiently loosened, slowly unclip the RAM compartment cover from its slots in the plastic chassis.

    • When unclipped completely, pull the compartment door out and away from the chassis.

    댓글 쓰기

    • Locate the wireless module next to the RAM slots.

    댓글 쓰기

    • Locate the gold connecting wire attached to the wireless module. It is labeled with a small sticker that has a circled number one.

    • Using a plastic spudger, disconnect the gold-end of the connecting wire from the wireless module.

    • Use a slow, prying motion as if pulling a nail out of wood.

    • Be very gentle with the gold wire and its respective port on the wireless module. Both are very fragile and can be easily ruined.

    댓글 쓰기

    • Locate the small Phillips head screw in the top right corner of the wireless module.

    • Using a #00 Phillips head screwdriver, remove the screw and set aside.

    • The wireless module should now pop up from its slot at a 45 degree angle.

    댓글 쓰기

    • Slowly slide the wireless module straight out from its slot in the logic board.

    • Maintain the 45 degree angle of the wireless module until all pins are disconnected. Failure to do so may result in breaking the wireless module connecting pins.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Conor Most

회원 가입일: 2014년 04월 14일

2,256 평판

안내서 6개 작성하였습니다

Cal Poly, Team 3-40, Maness Spring 2014 Cal Poly, Team 3-40, Maness Spring 2014 회원

CPSU-MANESS-S14S3G40

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 12

전체 시간: 1,094