HP 8 1401 Power/ Volume Button Board Replacement

소개

This guide can help if your power or volume buttons are broken. The power/ volume board may not be completely attached to the control board so be careful when unhooking the clip.

필요한 것

1 단계 Back Panel

HP 8 1401 Power/ Volume Button Board Replacement, Back Panel: 1 단계, 이미지 1/1

Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.

편집

2 단계

Insert the tip of a plastic opening tool in the seam between the front and back panels.

편집

3 단계

Slide the plastic opening tool around all edges of the device until the back panel detaches.
Lift off the back panel.

편집

4 단계 Power/ Volume Button Board

HP 8 1401 Power/ Volume Button Board Replacement, Power/ Volume Button Board: 4 단계, 이미지 1/3

HP 8 1401 Power/ Volume Button Board Replacement, Power/ Volume Button Board: 4 단계, 이미지 2/3

HP 8 1401 Power/ Volume Button Board Replacement, Power/ Volume Button Board: 4 단계, 이미지 3/3

Disconnect the power/ volume button board from the control board by pulling the ribbon cable out of the white connector. You can use tweezers or your fingers.

편집