부품

부품은 필요하지 않습니다.

Remove one 9mm T10 Torx screw from the back of the printer lid.
  • Remove one 9mm T10 Torx screw from the back of the printer lid.

댓글 쓰기

Press outward on the plastic tab holding the back panel in place. Press outward on the plastic tab holding the back panel in place.
  • Press outward on the plastic tab holding the back panel in place.

댓글 쓰기

Pull the back panel towards you and lift it away from the rest of the printer cover. Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.
  • Pull the back panel towards you and lift it away from the rest of the printer cover.

  • Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Tim

회원 가입일: 2013년 01월 15일

131 평판

안내서 4개 작성하였습니다

Cal Poly, Team 18-35, Regan Winter 2013 Cal Poly, Team 18-35, Regan Winter 2013 회원

CPSU-REGAN-W13S18G35

5 회원들

안내서 8개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 5

지난 30일: 23

전체 시간: 1,550