주요 콘텐츠로 건너뛰기
  1. Make sure the device is turned off before starting.
    • Make sure the device is turned off before starting.

    • Orient the device so the back is facing you, with the kickstand up.

  2. Remove the six 3mm Torx T5 screws underneath the kickstand. Remove the six 3mm Torx T5 screws underneath the kickstand. Remove the six 3mm Torx T5 screws underneath the kickstand.
    • Remove the six 3mm Torx T5 screws underneath the kickstand.

  3. Turn the device over so the screen is facing you. Place a suction cup firmly onto a corner of the screen.
    • Turn the device over so the screen is facing you.

    • Place a suction cup firmly onto a corner of the screen.

    • Lift up gently until you see the screen separate from the casing.

    • Repeat this process for all four corners.

  4. Lift the screen up and off of the device.
    • Lift the screen up and off of the device.

    • Pry each corner up first, otherwise you may damage or crack the screen.

  5. Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently. Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently. Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently.
    • Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently.

  6. Remove the screen by gently lifting it off of the device. Remove the screen by gently lifting it off of the device.
    • Remove the screen by gently lifting it off of the device.

  7. Identify the speaker locations.
    • Identify the speaker locations.

  8. Remove the antennae connections from both the WiFi card and the wireless cellular M.2 card. Gently pull the black and red wire free at the motherboard connector.
    • Remove the antennae connections from both the WiFi card and the wireless cellular M.2 card.

    • Gently pull the black and red wire free at the motherboard connector.

  9. Use the spudger tool to remove the speakers from the housing. Use the spudger tool to remove the speakers from the housing. Use the spudger tool to remove the speakers from the housing.
    • Use the spudger tool to remove the speakers from the housing.

  10. On the right speaker, the black antena piece must be removed before the speaker can be accessed. On the right speaker, the black antena piece must be removed before the speaker can be accessed.
    • On the right speaker, the black antena piece must be removed before the speaker can be accessed.

  11. Now remove the green and white wires from the cable management track and the speakers will be completely removed from the device. Now remove the green and white wires from the cable management track and the speakers will be completely removed from the device.
    • Now remove the green and white wires from the cable management track and the speakers will be completely removed from the device.

결론

To reassemble your device, follow these instructions in reverse order.

WesleyEagleson

회원 가입일: 2019년 04월 06일

337 평판

안내서 3개 작성하였습니다

IUPUI, Team S13-G13, Wilson Spring 2019 IUPUI, Team S13-G13, Wilson Spring 2019 회원

IUPUI-WILSON-S19S13G13

4 회원들

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 7

30일 전: 16

전체 시간: 109