주요 콘텐츠로 건너뛰기

소개

Prerequisite Only

부품

지정된 부품이 없습니다.

  1. Press locking latch on the bottom of the base of the stand. Pull the plastic cover off of the stand.
    • Press locking latch on the bottom of the base of the stand.

    • Pull the plastic cover off of the stand.

  2. Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit. Tilt stand and lift up to remove it.
    • Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.

    • Tilt stand and lift up to remove it.

  3. Use a Torx T15 driver to remove the single 10mm screw on the back panel. Pull the back panel toward the bottom of the device to remove it.
    • Use a Torx T15 driver to remove the single 10mm screw on the back panel.

    • Pull the back panel toward the bottom of the device to remove it.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Michael Ewing

회원 가입일: 2015년 10월 01일

905 평판

안내서 4개 작성하였습니다

Cal Poly, Team 1-24, Maness Fall 2015 Cal Poly, Team 1-24, Maness Fall 2015 회원

CPSU-MANESS-F15S1G24

4 회원들

안내서 14개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 2

지난 7일: 11

지난 30일: 42

전체 시간: 1,241