소개

Replace the keyboard in your HP Mini 1000.

부품

부품은 필요하지 않습니다.

With the case closed, place the Mini 1000 top-side down on a flat surface.
  • With the case closed, place the Mini 1000 top-side down on a flat surface.

  • Push both of the battery release latches toward each other.

댓글 쓰기

Lift the battery out of the Mini 1000 from the edge closest to the release latches.
  • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

댓글 쓰기

  • Remove the following two screws:

    • One 6 mm Phillips screw

    • One 4 mm Phillips screw

댓글 쓰기

  • To facilitate the removal of the keyboard, it is recommended to push the keyboard outwards with one hand through the opening (highlighted in the third picture) located on the backside of the Mini 1000.

  • While pushing through the opening with one hand, grasp the left upper edge with the other hand and slightly pull the keyboard towards you.

  • Once an opening has been established, grasp the keyboard and slowly lift it upwards along the upper perimeter of the top edge.

댓글 쓰기

  • Lift the keyboard out of the upper case, minding the cable that is still connecting it to the motherboard.

댓글 쓰기

  • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the keyboard cable ZIF socket.

  • Be sure you are prying up on the retaining flap, not the socket itself.

  • Pull the cable out of its socket and remove the keyboard.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 5명이 해당 안내서를 완성하였습니다.

Walter Galan

557,260 평판

안내서 2,895개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 7

지난 30일: 26

전체 시간: 8,781