주요 콘텐츠로 건너뛰기

HP Mini 1000 USB & Power Board Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

필요한 것

  1. HP Mini 1000 USB & Power Board Replacement, USB & Power Board: 1 단계, 이미지 1/1
    • If present, remove the two pieces of tape covering the cables routed near the USB and power board.

  2. HP Mini 1000 USB & Power Board Replacement: 2 단계, 이미지 1/1
    • Use a pair of tweezers to pull the internal display switch cable straight away from its socket on the USB and power board.

  3. HP Mini 1000 USB & Power Board Replacement: 3 단계, 이미지 1/1
    • Peel and de-route the SIM card ribbon cable from its channel on top of the underside of the battery compartment.

    • The SIM card ribbon cable is still connected to the USB and power board. Do not completely remove it yet.

  4. HP Mini 1000 USB & Power Board Replacement: 4 단계, 이미지 1/1
    • Remove the single 3 mm Phillips screw that secures the USB and power board as well as the DC jack bracket to the lower case.

  5. HP Mini 1000 USB & Power Board Replacement: 5 단계, 이미지 1/2 HP Mini 1000 USB & Power Board Replacement: 5 단계, 이미지 2/2
    • Lift the DC jack bracket up off the USB and power board.

  6. HP Mini 1000 USB & Power Board Replacement: 6 단계, 이미지 1/2 HP Mini 1000 USB & Power Board Replacement: 6 단계, 이미지 2/2
    • Grasp the USB and power board from its left edge, nearest the ports side.

    • Remove the USB and power board straight away from its recess in the lower case, minding any cables that may get tangled.

결론

To reassemble your device, follow these instructions in reverse order.

Walter Galan

693,685 평판

안내서 1,203개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 34