소개
The motherboard should be replaced if the laptop will not turn on with the charger plugged in. To avoid damaging electronic components, use a static discharge wrist strap. The only skill needed to complete this project is knowing how to use a screwdriver. With twenty minutes and a new motherboard, you can repair your computer for a fraction of the cost of replacing it.
필요한 것
-
-
Slide the battery lock latch on the left to unlock. Slide from left to right to unlock.
-
-
-
Flip computer over so that the bottom is facing the ceiling and the hinges are farthest from you.
-
-
-
Using the Phillips #1 screwdriver, remove the two 12mm screws located on the hinge covers.
-
-
-
-
Disconnect the wiring harness that is routed through the speaker from the motherboard.
-
Remove the wiring harness from the groove in the speaker.
-
-
-
Use the #000 screwdriver to remove the four 6mm screws attaching the motherboard to the laptop case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.