메인 콘텐츠로 스킵하기

소개

This guide will show you how to replace the screen on a HP Photosmart M547 in order to fix your device.

부품

지정된 부품이 없습니다.

  1. Disconnect from all power sources. (Remove batteries, chargers, etc.) Disconnect from all power sources. (Remove batteries, chargers, etc.) Disconnect from all power sources. (Remove batteries, chargers, etc.)
    • Disconnect from all power sources. (Remove batteries, chargers, etc.)

  2. Remove the five 5mm screws from the bottom of the camera with a PH00 screwdriver. Remove the five 5mm screws from the bottom of the camera with a PH00 screwdriver.
    • Remove the five 5mm screws from the bottom of the camera with a PH00 screwdriver.

  3. Pop the silver siding off of the camera. Proceed carefully as to not break the plastic.
    • Pop the silver siding off of the camera. Proceed carefully as to not break the plastic.

  4. 아이폰 배터리 수리 키트

    Only $29.99

    Buy Now

    아이폰 배터리 수리 키트

    Only $29.99

    Buy Now
  5. Make sure that the siding is fully removed and the battery dock is open. Carefully pry the top off of the camera. Make sure that the siding is fully removed and the battery dock is open. Carefully pry the top off of the camera.
    • Make sure that the siding is fully removed and the battery dock is open. Carefully pry the top off of the camera.

  6. Approach from the front of the camera, make sure that the black/red wires as not covering the screw.
    • Approach from the front of the camera, make sure that the black/red wires as not covering the screw.

    • Carefully remove the black 5mm screw from the camera with a PH00 screwdriver.

  7. Flip the camera over and pop off the plastic siding.
    • Flip the camera over and pop off the plastic siding.

  8. Look for the silver 5mm screw connecting the screen to the circuit board. Then carefully remove it using a PH00 screwdriver. On the opposite corner of the screen there is a similar screw. Carefully remove that one as well.
    • Look for the silver 5mm screw connecting the screen to the circuit board. Then carefully remove it using a PH00 screwdriver.

    • On the opposite corner of the screen there is a similar screw. Carefully remove that one as well.

    • You may need to peel back thin, black plastic to get to the screw. The plastic is purely there for dust protection.

  9. When you lift the screen off of the rest of the camera, you will see a small piece of ribbon wire connecting the screen and circuit board.
    • When you lift the screen off of the rest of the camera, you will see a small piece of ribbon wire connecting the screen and circuit board.

    • To remove this connection, you must lift the black bar at the base of the ribbon wire (on the circuit board), then slide the ribbon wire out.

  10. Congratulations! You have removed the screen, you can now replace it and reassemble your camera.
    • Congratulations! You have removed the screen, you can now replace it and reassemble your camera.

결론

To reassemble your device, follow these instructions in reverse order.

Jason Curran

회원 가입일: 2017년 02월 08일

101 평판

안내서 1개 작성함

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 3

지난 30일: 8

전체 시간: 65