Shut the device off.
  • Shut the device off.

  • Lift the top cover of the scanner.

  • Carefully, pry the plastic frame surrounding the glass away from the printer hood using a plastic prying tool.

  • Pull the frame out.

댓글 쓰기

Unscrew the two screws that fasten the frame to the printer hood. Use a T10 screwdriver
  • Unscrew the two screws that fasten the frame to the printer hood. Use a T10 screwdriver

댓글 쓰기

  • Pushing the clip behind the cover piece in, pull the cover piece outwards.

댓글 쓰기

  • Remove the two screws on the front of the printer with a T10 screwdriver.

    • The first is inside the power button panel space and the second is across the printer slider.

댓글 쓰기

  • Pull the circuit board from the power button panel space.

  • Unplug the small ribbon cable from the circuit board.

댓글 쓰기

  • Pull the memory card reader's circuit board out of its slot.

  • Detach the rainbow connector from the back of the circuit board.

댓글 쓰기

  • Press the clip directly behind the TouchSmart panel and pull the panel up.

  • Disconnect the ribbon cable from the TouchSmart panel. This detaches the panel from the printer body.

  • Do not hesitate to use force to remove the TouchSmart panel.

댓글 쓰기

  • Grip the printer hood and pull upward.

댓글 쓰기

  • With the top half of the printer separated, lift the upper section with the scanner glass away from the lower section of the printer.

댓글 쓰기

  • With the glass facing upwards, remove the screw holding the glass in place.

댓글 쓰기

  • Lift the glass up and away from the printer.

  • Handle glass with care.

  • Replace the broken glass piece with the replacement glass

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

garrett hall

회원 가입일: 2012년 09월 26일

49 평판

안내서 2개 작성하였습니다

Cal Poly, Team 2-11, Propen Fall 2012 Cal Poly, Team 2-11, Propen Fall 2012 회원

CPSU-PROPEN-F12S2G11

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 16

전체 시간: 2,326