기기를 수리하세요 커뮤니티 상점

HP iPAQ H3850 Screen Replacement

소개

Is your screen for your HP iPAQ H3850 cracked or not working? Don't worry, you can easily replace the screen using this guide.

The screen is a component that lets you see what you are doing on the iPAQ. It might be hard to see what is happening on the screen if it is cracked.

Before beginning this repair, make sure that the iPAQ is turned off.

필요한 것

  1. HP iPAQ H3850 Screen Replacement, Screen: 1 단계, 이미지 1/1

    • To begin the disassembly of the device, place it on a flat surface with the screen facing down.

    번역하기

  2. HP iPAQ H3850 Screen Replacement: 2 단계, 이미지 1/1

    • Remove the four screws found on the back cover of the device.

    번역하기

  3. HP iPAQ H3850 Screen Replacement: 3 단계, 이미지 1/1

    • Carefully remove the back cover using the spudger against the grooves along the sides of the iPAQ.

    번역하기

  4. HP iPAQ H3850 Screen Replacement: 4 단계, 이미지 1/1

    • At this point, a yellow ribbon will be connecting both the front and back panels of the device. Carefully use the plastic opening tool to detach the ribbon from the connector pins.

    번역하기

  5. HP iPAQ H3850 Screen Replacement: 5 단계, 이미지 1/1

    • Remove SD card on top of device by pushing and then releasing.

    번역하기

  6. HP iPAQ H3850 Screen Replacement: 6 단계, 이미지 1/1

    • Remove the ribbon cable connected to display logic board by pulling the plastic clips on both sides towards top of device.

    • Use plastic opening tool to carefully pull brown ribbon cable from connector.

    번역하기

  7. HP iPAQ H3850 Screen Replacement: 7 단계, 이미지 1/3 HP iPAQ H3850 Screen Replacement: 7 단계, 이미지 2/3 HP iPAQ H3850 Screen Replacement: 7 단계, 이미지 3/3

    • Use the plastic opening tool to carefully remove the display logic board from its housing.

    • Unplug connector from the opposite end of the display logic board.

    • Completely remove component.

    번역하기

  8. HP iPAQ H3850 Screen Replacement: 8 단계, 이미지 1/1

    • Flip up black plastic clip on large ribbon cable connector located towards center of mother board.

    • Use plastic opening tool to carefully remove ribbon cable from connector.

    번역하기

  9. HP iPAQ H3850 Screen Replacement: 9 단계, 이미지 1/1

    • Locate clear/grey ribbon cable in bottom corner of device.

    • Gently pry cable out of connector with plastic opening tool.

    • Use hands or tweezers to remove if necessary.

    번역하기

  10. HP iPAQ H3850 Screen Replacement: 10 단계, 이미지 1/1

    • Use your hands to gently unplug the speaker and microphone connectors from the mother board.

    번역하기

  11. HP iPAQ H3850 Screen Replacement: 11 단계, 이미지 1/1

    • Remove three small screws from each corner of the motherboard using phillips head screwdriver.

    • Use your hands/plastic opening tool to carefully lift the mother board out of housing.

    • Place the motherboard to the side.

    번역하기

  12. HP iPAQ H3850 Screen Replacement: 12 단계, 이미지 1/1

    • Locate the four blue plastic clips surrounding the square screen housing.

    • Pry back clips with your hands.

    • Use the plastic opening tool to remove the entire screen assembly from the housing.

    번역하기

    • Insert new screen into device.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 7명과 함께

Carson Horton

회원 가입일: 04/05/15

131 평판

안내서 1개 작성함

배지: 7

배지 +4개 더

팀

Eastern Washington University, Team 1-3, Plummer Spring 2015 Eastern Washington University, Team 1-3, Plummer Spring 2015 회원

EWU-PLUMMER-S15S1G3

4 회원들

안내서 5개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 2

전체 시간: 336