메인 콘텐츠로 스킵하기
  1. Slide the silver release tab up and simultaneously lift the cover up from the left side.
    • Slide the silver release tab up and simultaneously lift the cover up from the left side.

  2. Push the tab from left to right to remove the cover.
    • Push the tab from left to right to remove the cover.

  3. Now lift the battery up and away from the device to remove it.
    • Now lift the battery up and away from the device to remove it.

  4. Remove the four silver screws (T5 x .25 in).
    • Remove the four silver screws (T5 x .25 in).

  5. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  6. Remove the single black screw (T5 x .125 in) beneath the HP sticker.
    • Remove the single black screw (T5 x .125 in) beneath the HP sticker.

  7. Next, use your plastic removal tool to separate the gray back from the black center piece. For better results, start the separation at the corner piece.
    • Next, use your plastic removal tool to separate the gray back from the black center piece.

    • For better results, start the separation at the corner piece.

  8. Remove the back case.
    • Remove the back case.

  9. Now that the back cover is removed, remove the small screw (#00 Philips x .17) to the left of the SD card slot
    • Now that the back cover is removed, remove the small screw (#00 Philips x .17) to the left of the SD card slot

  10. Next you will need to unlock and remove the ribbon cable Carefully pull back on both sides of the brown bar using metal tweezers, unlocking the cable and slipping it out of the connector
    • Next you will need to unlock and remove the ribbon cable

    • Carefully pull back on both sides of the brown bar using metal tweezers, unlocking the cable and slipping it out of the connector

    • The bar, connector, and cable are fragile components that can be easily broken

  11. Next you need to remove the wire off the bottom of the mother board The easiest method is to use some metal tweezers and grip the plug close to the connector.
    • Next you need to remove the wire off the bottom of the mother board

    • The easiest method is to use some metal tweezers and grip the plug close to the connector.

    • Make sure all these connections are properly disconnected before separation of the motherboard

  12. Next use your plastic removal tool and separate the silver front case from the black frame.
    • Next use your plastic removal tool and separate the silver front case from the black frame.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

John Pagliero

회원 가입일: 2011년 01월 27일

897 평판

안내서 7개 작성하였습니다

Cal Poly, Team 3-39, Regan Winter 2011 Cal Poly, Team 3-39, Regan Winter 2011 회원

CPSU-REGAN-W11S3G39

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 4

전체 시간: 1,205