Hamilton-T1 Oxygen Cells Replacement - iFixit 수리 안내서

소개

This guide is created for the replacement of oxygen cells in the Hamilton-T1 Ventilator. Replacing the oxygen cells is a crucial step in maintaining and keeping a working ventilator.

NOTE:

Replace the oxygen cell with genuine Hamilton Medical parts only; otherwise, oxygen measurement will not function. To prevent a permanent alarm make sure to use special Hamilton Medical oxygen cells only.
To prevent leakage within the ventilator, make sure an oxygen cell is installed at all times, even if you use an external monitor or disable oxygen monitoring.

필요한 것

1 단계 Oxygen Cells

Hamilton-T1 Oxygen Cells Replacement, Oxygen Cells: 1 단계, 이미지 1/1

Flip device around until the back panel is exposed.

2 단계

Hamilton-T1 Oxygen Cells Replacement: 2 단계, 이미지 1/1

Remove the screw in the bottom center of the panel, and then take the panel off.

3 단계

Hamilton-T1 Oxygen Cells Replacement: 3 단계, 이미지 1/1

Disconnect the oxygen cell by removing the tube.
Then twist the cell counter-clockwise and pull to remove the oxygen cell.
Install the new oxygen cell and put the back cover on.

4 단계

After the cell is installed. Run the oxygen cell calibration.
Oxygen calibration guide can be found in 3-11 of the Hamilton-T1 operations manual.

결론

After the installation and calibration of the oxygen cell. The Hamilton-T1 Ventilator is ready to operate.

첨부 문서

HAMILTON-T1 Operator's Manual SW2.1x EN

PDF - 4.17 mb

보기

작성자

다른 기여자 1명과 함께

Tyler

회원 가입일: 04/09/20

114 평판

안내서 1개 작성함

+1개 배지 추가

팀

Cal Poly, Team S11-G24, Paton Spring 2020 Cal Poly, Team S11-G24, Paton Spring 2020 회원

CPSU-PATON-S20S11G24

3 회원들

안내서 3개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 2

7일 전: 19

30일 전: 64

전체 시간: 2,248