소개

Use this guide to replace the Touch Screen.

부품

부품은 필요하지 않습니다.

Remove the outer screen cover by releasing  the top clip from the main body of the device. Remove the outer screen cover by releasing  the top clip from the main body of the device.
  • Remove the outer screen cover by releasing the top clip from the main body of the device.

댓글 쓰기

Pull out the stylus from the top right corner of the device. Pull out the stylus from the top right corner of the device. Pull out the stylus from the top right corner of the device.
  • Pull out the stylus from the top right corner of the device.

댓글 쓰기

Slide the memory cartridge cover up and off the device. Slide the memory cartridge cover up and off the device. Slide the memory cartridge cover up and off the device.
  • Slide the memory cartridge cover up and off the device.

댓글 쓰기

Mac RAM 키트
Mac 속도를 높이십시오. 메모리를 최대한 활용하십시오.
Mac RAM 키트
Mac에서 메모리를 더 많이 확보하십시오.
Remove the battery cover by releasing the clip from the main body of the device. Remove the battery cover by releasing the clip from the main body of the device.
  • Remove the battery cover by releasing the clip from the main body of the device.

댓글 쓰기

Remove the batteries from the device.
  • Remove the batteries from the device.

댓글 쓰기

Unscrew the four 2.94mm screws with a #00 Phillips screwdriver.
  • Unscrew the four 2.94mm screws with a #00 Phillips screwdriver.

  • One end of the OEM stylus can unscrew and contains a mini #00 Phillips screwdriver.

댓글 쓰기

Use the spudger to pry open the casing by applying pressure at 4 clips on both sides of the device. Be careful while opening the casing as there is a flex strip connecting the two halves. Be careful while opening the casing as there is a flex strip connecting the two halves.
  • Use the spudger to pry open the casing by applying pressure at 4 clips on both sides of the device.

  • Be careful while opening the casing as there is a flex strip connecting the two halves.

댓글 쓰기

Disconnect the flex strip from the motherboard with tweezers. Disconnect the flex strip from the motherboard with tweezers. Disconnect the flex strip from the motherboard with tweezers.
  • Disconnect the flex strip from the motherboard with tweezers.

댓글 쓰기

Release the latch in bottom right corner of the touchscreen. Use the spudger (if needed) to pry the screen from the front case. Use the spudger (if needed) to pry the screen from the front case.
  • Release the latch in bottom right corner of the touchscreen.

  • Use the spudger (if needed) to pry the screen from the front case.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

David Faltemier

회원 가입일: 2012년 06월 20일

19 평판

안내서 5개 작성하였습니다

Cal Poly, Team 1-2, Regan SU 2012 Cal Poly, Team 1-2, Regan SU 2012 회원

CPSU-REGAN-SU12S1G2

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 508