기기를 수리하세요 커뮤니티 상점

Holmes HEH8031 Safety Weight Replacement

소개

This guide will demonstrate how to remove and replace the safety weight in the Holmes HEH8031 Heater.

필요한 것

  1. Holmes HEH8031 Safety Weight Replacement, Housing: 1 단계, 이미지 1/1

    • Ensure the device is unplugged from the wall outlet.

    편집

  2. Holmes HEH8031 Safety Weight Replacement: 2 단계, 이미지 1/1

    • Remove eight 12-mm Phillips #2 screws from the back cover.

    편집

  4. Holmes HEH8031 Safety Weight Replacement: 3 단계, 이미지 1/2 Holmes HEH8031 Safety Weight Replacement: 3 단계, 이미지 2/2

    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

    편집

  5. Holmes HEH8031 Safety Weight Replacement, Circuit Board Removal: 4 단계, 이미지 1/1

    • Remove four 12mm Phillips #2 screws from the circuit board.

    편집

  6. Holmes HEH8031 Safety Weight Replacement, Safety Weight: 5 단계, 이미지 1/2 Holmes HEH8031 Safety Weight Replacement, Safety Weight: 5 단계, 이미지 2/2

    • Remove wires from safety weight, as shown.

    • Pull upward on the blue connectors.

    • If connectors are tough to remove, try wiggling while pulling upward.

    편집

  7. Holmes HEH8031 Safety Weight Replacement: 6 단계, 이미지 1/1

    • Unscrew the Phillips #2 10 mm screw from the safety weight on the rear housing panel.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Deanna Jack

회원 가입일: 10/12/16

333 평판

안내서 4개 작성하였습니다

배지: 13

배지 +10개 더

팀

IUPUI, Team 2-1, Baechle Fall 2016 IUPUI, Team 2-1, Baechle Fall 2016 회원

IUPUI-BAECHLE-F16S2G1

4 회원들

안내서 16개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 4

전체 시간: 538