소개

This guide is created to replace a damaged or broken back wheel. Tools required are a Hex Bit 4.0 tool, a bit extender, and an allen key.

부품

부품은 필요하지 않습니다.

  1. Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
    • Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

    • The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

    • Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

    댓글 쓰기

  2. Slide off the plastic side panel.
    • Slide off the plastic side panel.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

    • You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don't spin freely.

    댓글 쓰기

    • Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

    댓글 쓰기

    • Slide off the other plastic side panel.

    댓글 쓰기

    • On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

    • The axle pops out and the wheel easily comes off.

    • Two washers will pop out with the axle.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Luke Imai

회원 가입일: 2018년 10월 08일

133 평판

안내서 1개 작성함

Cal Poly, Team S15-G5, White Fall 2018 Cal Poly, Team S15-G5, White Fall 2018 회원

CPSU-WHITE-F18S15G5

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 17

전체 시간: 33