Hover-1 Horizon Power Button Replacement

소개

Does your Hover-1 Horizon not turn off? This is a guide to show you how to replace the power button, the most likely cause of your issue. This guide requires a Phillips #2 and a Phillips #1 screwdriver.

필요한 것

1 단계 Base Plate

Hover-1 Horizon Power Button Replacement, Base Plate: 1 단계, 이미지 1/2

Hover-1 Horizon Power Button Replacement, Base Plate: 1 단계, 이미지 2/2

Remove the six 12mm Phillips #2 screws holding the base plate.

편집

2 단계

Remove the two 11mm Phillips #1 screws that hold the base plate to the body.

편집

3 단계

Hover-1 Horizon Power Button Replacement: 3 단계, 이미지 3/3

Remove the base plate by lifting it up.
The base plate is connected to the body with wires. The wires are long enough to set the base plate to the side.

편집

4 단계 Power Button

Hover-1 Horizon Power Button Replacement, Power Button: 4 단계, 이미지 1/1

Reorient the Hover-1 Horizon so the base plate opens towards you.

편집

5 단계

Hover-1 Horizon Power Button Replacement: 5 단계, 이미지 3/3

Remove the connector by squeezing the tab and lifting up.

편집

6 단계

Hover-1 Horizon Power Button Replacement: 6 단계, 이미지 3/3

Remove the second connector by squeezing the tab and pulling up.

편집

7 단계

Hover-1 Horizon Power Button Replacement: 7 단계, 이미지 3/3

Unscrew the power button by holding the front and twisting the back nut counter-clockwise.
Push the power button through the base plate to remove.
A hot air gun may need to be used to remove the adhesive connecting the base plate to the power button.