주요 콘텐츠로 건너뛰기

What you need

  1. How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban, How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 1 단계, 이미지 1/1
    • Locate the wiring harness bundle, which exits the firewall underneath the brake booster.

  2. How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 2 단계, 이미지 1/1
    • Identify the auxiliary wire, which is folded and taped to either the wiring harness or the fire wall.

  3. How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 3 단계, 이미지 1/1
    • Use a knife to cut the tape away from the wire and unravel it.

  4. How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 4 단계, 이미지 1/1
    • Run the wire against the battery box.

  5. How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 5 단계, 이미지 1/3 How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 5 단계, 이미지 2/3 How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 5 단계, 이미지 3/3
    • Place the ring terminal (washer end) of the wire on the right post located at the front of the battery.

    • Place the 10 mm washer on the post.

    • Tighten the washer using a 10 mm wrench, crescent wrench, or pliers.

    • Post size and location may vary slightly in different models. The washer will fit snuggly around the correct post.

    Y'all may want to say that it takes a m6 bolt to lock it down.

    Grayson Judd - 답글

    What is the left post for? It is constant hot as well, at least on my truck. Can’t seem to find anything showing which fuse feeds it.

    Robert Abraham - 답글

  6. How to Activate 12 V Aux Power in a 2007-2014 Chevrolet Suburban: 6 단계, 이미지 1/1
    • After hooking up the wire, check to make sure the 40 amp fuse is installed for the auxiliary pin.

    • If the fuse is not installed, there will be an empty space. This fuse can be purchased at any automotive shop.

    It’s not a break booster, it is a brake booster. If you are going to be an author, you should know the meaning of the words you use.

    Albert - 답글

    I’m sure it was a simple mistake. There’s no need to talk so tough cyber warrior.

    nshourds -

    THANK YOU! I scratched my head for a week trying to get this auxiliary working….after I found your information on this sight. it took less than 5 minutes to hook it up (would’ve only took 2 minutes, but I had to go back and clean the wire terminal end…then it worked!)…..and another sight on the internet wanted me to pay them 5 bucks for this same information! So, again, thank you very much!!!

    darrelwt - 답글

    What is the purpose of the other terminal, next to aux power connector?

    Rhohon - 답글

결승점

다른 12명이 해당 안내서를 완성하였습니다.

Lauryn Johnson

회원 가입일: 2016년 01월 19일

422 평판

안내서 1개 작성함

Team

Oakland University, Team 6-14, Walwema Winter 2016 Oakland University, Team 6-14, Walwema Winter 2016 회원

OAK-WALWEMA-W16S6G14

1 회원

안내서 1개 작성하였습니다

6 Comments

This sends constant power to the trailer. What if I wanted to make that power switched by the ignition so when the key is off I can be confident that the trailer won't kill my truck battery? I know I can just unplug the trailer harness or pull this fuse to stop it, but That might be easy to forget to do.

Eric Wonderlich Jr. - 답글

Eric, did you ever get an answer to your inquiry about killing the power to the trailer when the key is in the off position?

Bobby Burke -

It’s not a break booster, it is a brake booster. If you are going to be an author, you should know the meaning of the words you use.

Albert - 답글

Never fails some troll somewhere..

Garry Foster -

“Words have meaning” geez Cyber Warrior. Tough talk from a distance. ?

nshourds -

What thread pitch of nut is it for the terminal stud.

Kenny Man - 답글

댓글 쓰기

조회 통계:

24 시간 전: 23

7일 전: 114

30일 전: 441

전체 시간: 29,015