주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

This guide will walk you through the quick and simple process of assembling a Mac Pro First Generation Hard Drive Sled Adapter. The existing hard drive bay sled brackets in this device are meant to fit 3.5" hard drives, but this adapter enables you to install any SATA 2.5" solid state, hybrid, or standard hard drive. It also correctly aligns the SATA connector to match the socket in your Mac Pro.

부품

지정된 부품이 없습니다.

  1. Insert the two tabs on the left side of the metal adapter bracket into the slots on the left side of the hard drive bay sled. Align the holes on the right side. Align the holes on the right side.
    • Insert the two tabs on the left side of the metal adapter bracket into the slots on the left side of the hard drive bay sled.

    • Align the holes on the right side.

  2. Screw the two 7.8mm PH0 screws into the two holes on the right.
    • Screw the two 7.8mm PH0 screws into the two holes on the right.

    • Leave these screws slightly loose; they will be tightened once the hard drive is attached.

  3. Align the holes in the hard drive with the three holes on the bracket. Screw the three 6.1mm PH0 screws into the bracket and hard drive. These screws can be secured tightly.
    • Align the holes in the hard drive with the three holes on the bracket.

    • Screw the three 6.1mm PH0 screws into the bracket and hard drive.

    • These screws can be secured tightly.

  4. Tighten the two 7.8mm PH0 screws on the right side of the bracket.
    • Tighten the two 7.8mm PH0 screws on the right side of the bracket.

결승점

Kristen Gismondi

회원 가입일: 2014년 11월 12일

40,684 평판

안내서 72개 작성하였습니다

iFixit iFixit 회원

Community

135 회원들

안내서 13,943개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 54