How to Unclog an Epson ET-2760 Printhead

소개

If your Epson ET-2760 printer is not printing complete lines and is having trouble printing a full color image, use this procedure to manually unclog the printhead.

The printhead supplies and transfers the ink onto the paper into the correct form for whatever is being printed, so before beginning, perform a head cleaning or a power cleaning to make sure that the issue must be dealt with manually. From here, the guide can be started following the steps below.

All of the following steps are easy to perform and require no prior skills. However, there is a chance that ink could get on one’s hands and clothes, so don't wear your favorite shirt!

필요한 것

1 단계 How to Unclog an Epson ET-2760 Printhead

How to Unclog an Epson ET-2760 Printhead, How to Unclog an Epson ET-2760 Printhead: 1 단계, 이미지 2개 중 1개

How to Unclog an Epson ET-2760 Printhead, How to Unclog an Epson ET-2760 Printhead: 1 단계, 이미지 2개 중 2개

Begin a print of any kind, or a nozzle check.
Once the print has begun, pull the power cable out mid-print.

편집

2 단계

Open the printer, then pull out the half-printed paper through the slot.
Place a thick paper towel or rag under the printhead.

편집

3 단계

How to Unclog an Epson ET-2760 Printhead: 3 단계, 이미지 3개 중 3개

Remove the single screw with a Phillips #0 screwdriver.
Unclip the two white plastic clips.
Lift the top cover off of the printhead.

편집

4 단계

Unclip the four ink cartridges from the printhead by pulling the small tabs on top of the cartridges.
Be sure not to disconnect the ink lines from the cartridges. Simply set the connected cartridges to the side of the printhead.

편집

5 단계

Fill a syringe with printhead cleaning solution and place the syringe tip over the holes left by the cartridges.

편집

6 단계

Begin to flush the manufacturer's recommended amount of solution through each hole onto the paper towel.
If necessary, swap out the paper towel in between flushes to prevent any solution from entering the printer.

편집