소개

This guide will help you to remove the cover plates from your Canon digital camera.

부품

부품은 필요하지 않습니다.

  1. Using a Tri-Wing screwdriver #0, remove the screws from the sides of the camera.
    • Using a Tri-Wing screwdriver #0, remove the screws from the sides of the camera.

      • There are two on each side, and two on the bottom plate.

    댓글 쓰기

  2. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
  3. Gently grip and remove the side cover while holding the Mini-USB cover open.
    • Gently grip and remove the side cover while holding the Mini-USB cover open.

    댓글 쓰기

    • Grip the camera from the sides and carefully remove the screen cover. Start at the bottom edge and slowly lift up the cover. Pay special attention to the area with the camera/video switch.

      • While still gripping the sides, remove the front cover. Again, start at the bottom edge and slowly lift up the cover. Once you are done with the screen cover, remove the screw by the power switch that is anchoring the side plate and the sides will come off.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Stanley

회원 가입일: 2011년 01월 30일

369 평판

안내서 4개 작성하였습니다

Cal Poly, Team 4-33, Regan Winter 2011 Cal Poly, Team 4-33, Regan Winter 2011 회원

CPSU-REGAN-W11S4G33

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 7

전체 시간: 4,907