주요 콘텐츠로 건너뛰기

Vent/Bleed Coolant System on BMW E60/E90

동영상 개요

    • Insert key in the dash or steering column.

    • With foot OFF the brake (don't want to start the car), push the start button (headlamps and interior systems come on).

    • Turn both temp dials as high as they will go and put the fan on the lowest setting.

    • Push the accelerator pedal in for ten seconds then let go - you will hear the water pump cycle on.

    • Set a timer for 12-15 minutes. In this time period, you will hear the water pump cycle on and off and coolant gurgling at the reservoir.

    • After 12-15 minutes turn the car off, remove the reservoir cap and check the fluid - it should be slightly below where you started.

    • Start your car. Watch your temperature. If the car will run without overheating you're done. If you will notice that the temperature is rising repeat these steps.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

lifeoftech

회원 가입일: 11/04/09

187 평판

안내서 1개 작성함

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 19

7일 전: 111

30일 전: 460

전체 시간: 26,731