주요 콘텐츠로 건너뛰기

부품

지정된 부품이 없습니다.

  1. Turn the boombox around to see the back, and then flip it upside down. Insert a 2.5mm flathead driver into the two holes next to the battery compartment.
    • Turn the boombox around to see the back, and then flip it upside down.

    • Insert a 2.5mm flathead driver into the two holes next to the battery compartment.

    • Turn the driver counterclockwise several times to loosen and pull out the 17mm screw.

  2. Peel off the two black square foams in front of the battery compartment to reveal a screw under each one.
    • Peel off the two black square foams in front of the battery compartment to reveal a screw under each one.

  3. Remove the two 8mm screws using a 2.5mm flathead driver. The front grey panel will loosen up once the final screw is removed.
    • Remove the two 8mm screws using a 2.5mm flathead driver.

    • The front grey panel will loosen up once the final screw is removed.

  4. Turn the boombox on its back.
    • Turn the boombox on its back.

    • Release the front panel by pushing down on the latches holding the panels together.

    • There are four silver latches on the top side of the panel and one on the bottom.

    • Do not force the panel comletely off, there are cables attached inside.

  5. Turn the boombox around to view the back and lift the handle up. Using the same driver with 2.5mm flathead, remove the two 14mm screws under the handle.
    • Turn the boombox around to view the back and lift the handle up.

    • Using the same driver with 2.5mm flathead, remove the two 14mm screws under the handle.

    • Gently lift the black top but do not pull completely away.

결론

To reassemble your device, follow these instructions in reverse order.

Cristina Ruiz

회원 가입일: 2016년 09월 12일

122 평판

안내서 1개 작성함

CSU Fullerton, Team 2-5, Bruce Fall 2016 CSU Fullerton, Team 2-5, Bruce Fall 2016 회원

CSUF-BRUCE-F16S2G5

4 회원들

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 30