기기를 수리하세요 커뮤니티 상점

Insignia NS-HD01A Battery Replacement

작성자 Joel Najmon (또 다른 기여자 3명)
  • 댓글 0
  • 즐겨찾기 0
  • 완료: 2

난이도

쉬움

단계

5

소요 시간

5 분

섹션

1

플래그

0

소개

This guide will show you how to remove the back cover and replace the battery in the radio. There will be several small screws and rubber covers so make sure you have a container to keep them in so that they are not lost.

  1. Remove the rubber screw caps using the pointed tip of the Spudger.

    • Remove the rubber screw caps using the pointed tip of the Spudger.

    편집

  2. Remove the four 6.0 mm Phillips screws located below the rubber caps using the PH00 bit installed in the driver.

    • Remove the four 6.0 mm Phillips screws located below the rubber caps using the PH00 bit installed in the driver.

    편집

  4. Use the plastic opening tool to pry open the back cover. Slide the tool around the sides of the radio to gradually pry the back cover off. Do not remove the cover completely as there is still a cable connecting it to radio.

    • Use the plastic opening tool to pry open the back cover.

    • Slide the tool around the sides of the radio to gradually pry the back cover off. Do not remove the cover completely as there is still a cable connecting it to radio.

    편집

  5. Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides. Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides. Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides.

    • Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides.

    편집

  6. Use the flat side of the Spudger to pry the battery out of the back cover. Insert the replacement battery into the back cover.

    • Use the flat side of the Spudger to pry the battery out of the back cover.

    • Insert the replacement battery into the back cover.

    • Reassemble the radio, making sure to reconnect the battery cable.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Joel Najmon

회원 가입일: 2016년 10월 08일

152 평판

안내서 1개 작성함

배지: 4

+1개 배지 추가

팀

IUPUI, Team 2-2, Wilson Fall 2016 IUPUI, Team 2-2, Wilson Fall 2016 회원

IUPUI-WILSON-F16S2G2

5 회원들

안내서 1개 작성하였습니다

댓글 0개

의견 추가하세요

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 5

30일 전: 19

전체 시간: 627