Insignia NS-SPBTBRICK-CM Auxiliary Port Replacement

소개

This guide gives an in depth explanation of replacing the auxiliary port in the Insignia Bluetooth Speaker. Read if you want step by step instructions on how to replace the auxiliary port. If you have any physical disability in your hand, wrist, or arm please consider having a different individual because these tasks require steady hands.

필요한 것

1 단계 Battery

주의: 1-4 단계들은 진행 중으로 표시된 안내서에서 제공되었습니다.

Insignia NS-SPBTBRICK-CM Auxiliary Port Replacement, Battery: 1 단계, 이미지 1/1

Remove the rubber sleeve.

번역하기

2 단계

Use the specified screwdriver to unscrew the ten screws on the back cover.

번역하기

3 단계

Remove the back cover. Be careful to not lose any of the screws because they are extremely small and can be easily lost.

번역하기

4 단계

Insignia NS-SPBTBRICK-CM Auxiliary Port Replacement: 4 단계, 이미지 3/3

The battery will be attached to the back cover with sticky tape. Unplug the wires connecting the battery to the speaker.

번역하기

5 단계 Auxiliary Port

Insignia NS-SPBTBRICK-CM Auxiliary Port Replacement, Auxiliary Port: 5 단계, 이미지 1/1

Once the battery and back cover have been successfully removed, use the sauter by placing the soldering iron on one side of the auxiliary port button.

번역하기

6 단계

이 단계에 사용된 도구:

Tweezers

$4.99

구매

Once the metal is heated, use a pair of tweezers to grab the part and pull it off of the circuit board. Be careful not to alter the circuit board in any way with the heat. Also, be careful when removing the part because the metal will be very hot.

번역하기

7 단계

Once the switch has been removed from the circuit board, place the new switch in the same spot as the old one.

번역하기

8 단계

Use the sauter to melt the new switch onto where the old switch was located.

번역하기

9 단계

Insignia NS-SPBTBRICK-CM Auxiliary Port Replacement: 9 단계, 이미지 3/3

After the new piece is properly melted into place, put the battery and back cover onto the device and screw the cover back on using the specified screwdriver and the ten screws.

번역하기